1 LOTOS MIG140 MIG Welder
10 POWER SUPPLY RATINGS MIG140 General Specifications Output Power DC Input Voltages 110 V, 1-PH, 50/60 Hz Dimensions 16” (408mm) L 9.6” (244mm
11 FRONT CONTROL PANEL The unit is connected to the supply even if the Power Switch is in the “OFF” position,
12 MACHINE REAR 1 The protector will cut off the circuit if
13 INSTALLATION PLEASE READ ENTIRE INSTALLATION SECTION BEFORE STARTING INSTALLATION. BE SURE THAT ONLY QUALIFIED PERSONNEL SHOULD PER
14 6Figure C-3 WELDING GUN INSTALLATION (See Figure C-1, C-2 and C-3) There is one spool of .025” (0.6mm) solid welding wire included with the
15 WELDNG WIRE INSTALLATION The MIG140 welding machine can use wire spools up to 8“ diameter (200mm) and a maximum width under 2” (50mm). If
16 Thread the Welding Wire through the Wire Feeder by following the instructions shown as below (Figure D-3) 1. Release the spring-loaded pressure
17 HoseRegulator Flow GaugeCylinder ValveInlet Connection For Shielding Gas SHIELDING GAS INSTALLATION Compressed gas cylinder containing mixed
18 OPERATION PLEASE READ AND UNDERSTAND THIS ENTIRE SECITON BEFORE OPERATING YOUR MACHINE. ONLY QUILIFIED PERSONNEL SHOULD OPERATE TH
19 WELDING PROCESS 1. Please refer to “Welding Control Guide” that is located inside the welding machine door for the output voltage and wire
2 TABLE OF CONTENTS SAFETY...…………………………………………………………………………4 SPECIFICATIONS…….………………………………………………………9 General Description…………………………………………………………...9 Wh
20 OTHER ACCESSORIES The following accessories and consumables can be purchased on www.uwelding.com, or call 408-739-2329 to order.
3 MIG140 MIG WELDER
4 SAFETY WARNINGS AND PRECAUTIONS PLEASE READ AND UNDERSTAND THE FOLLOWING SAFETY HIGHLIGHTS. BE SURE THAT ALL INSTALLATION, OPERATION, MAINT
5 Avoid starting unintentionally. Be sure the switch is in the off position when not in use and before plugging in. Do not carry any tool with you
6 ELECTRIC SHOCK can be fatal The electrode and work (or ground) circuits are electrically “hot” when the machine is on. Do not touch these
7 ARC RAYS can burn Avoid eye and body damage. Arc rays and infrared radiation can cause injury to the eyes and burn the skin. Wear
8 ELECTRICALLY POWERED EQUIPMENT can be dangerous Turn off input power using the disconnect switch at the fuse box before worki
9 SPECIFICATIONS GENERAL DESCRIPTION The LOTOS MIG140 features a 140 amp MIG welder that can weld at industrial quality and per
Comments to this Manuals