1 LOTOS MIG175 MIG Welder
10 POWER SUPPLY RATINGS MIG175 General Specification Output Power DC Input Voltages 200-240V, 1-PH, 50/60 Hz Input Current 22A @220V Power Factor
11 MACHINE REAR The unit is connected to the supply even if the Power Switch is in the “OFF” position, and therefore there are ele
12 SIDE COMPONENTS SIDE COMPONENTS 1 Positive (+) and negative (-) output terminals 2 Wing screw to fasten the welding torch ca
13 INSTALLATION PLEASE READ ENTIRE INSTALLATION SECTION BEFORE STARTING INSTALLATION. BE SURE THAT ONLY QUALIFIED PERSONNEL SHOULD PER
14 WIRE FEEDER INSTALLATION The wire feed drive roller attached to MIG175 has two wire grooves, one for 0.023” (0.6 mm) welding wire and another
15 HOW TO THREAD WELDING WIRE THROUGH THE WIRE FEEDER 1. Unlock the tension bar (1) on the wire tensioner and lift up the rocker arm (2). Insure
16 SHIELDING GAS INSTALLATION A compressed gas cylinder containing 75% Argon and 25% CO2 should be used when using the MIG (GMAW - GAS Metal Arc
17 OPERATION PLEASE READ AND UNDERSTAND THIS ENTIRE SECITON BEFORE OPERATING YOUR MACHINE. ONLY QUILIFIED PERSONNEL SHOULD OPERATE TH
18 WELDING PROCESS 1. Please refer to “Welding Label” in the unit and select proper setting based on the variety of metals and their thickness.
19 OVERLOAD PROTECTION Overload protection for power supply to welding Your MIG175 is equipped with a temperature controller as well as an overl
2 TABLE OF CONTENTS SAFETY...…………………...……………………………………………………………4 SPECIFICATIONS…………..….………………………………………………………9 General Description……………………………………………………
20 WELDING LABEL
21 OTHER ACCESSORIES The following accessories and consumables can be purchased on www.uwelding.com, or call 408-739-2329 to order. CO
3 MIG175 MIG WELDER
4 SAFETY WARNINGS AND PRECAUTIONS PLEASE READ AND UNDERSTAND THE FOLLOWING SAFETY HIGHLIGHTS. BE SURE THAT ALL INSTALLATION, OPERATION, MAINT
5 before plugging in. Do not carry any tool with your finger on the trigger, whether it is plugged in or not. Stay alert. Watch what you are doing
6 ELECTRIC SHOCK can be fatal The electrode and work (or ground) circuits are electrically “hot” when the machine is on. Do not touch these
7 ARC RAYS can burn Avoid eye and body damage. Arc rays and infrared radiation can cause injury to the eyes and burn the skin. Wea
8 ELECTRICALLY POWERED EQUIPMENT can be dangerous Turn off input power using the disconnect switch at the fuse box before worki
9 SPECIFICATIONS GENERAL DESCRIPTION The LOTOS MIG175 is one of the most versatile welders. It is able to weld aluminum with the spool gun. I
Comments to this Manuals